Make sure that all the fields within the "config.yml"; If there are no broadcasters running be sure the "ENGINE0" is set to true, vice versa.
Make sure that all the files are inside the folder! (If not then restart the plug-in)
Be sure to read all the information within the "/FILES/INFO.txt" file, it will show examples on how to use the "config.yml" file.
The commands won't save my configurations!
It's NOT suggested to use the commands to configure Broadcaster while the server is running. Turn it off then re-do the config.yml
The broadcasts are going too fast!
Make sure you have the "interval:" field set to the preferred time.
Check your interval type "intervalType:". It can only be set to these four values: MILLISECONDS, SECONDS, MINUTES, and HOURS. (These are NOT case-sensitive)
Make sure the interval type is inside the correct field. Ex: "intervalType: SECONDS".
The broadcasts aren't starting up when I enable them!
Make sure you have the "delay:" field set to the preferred time. If you don't want it to be delayed then set it to 0.
Check your delay type "delayType:". It can only be set to these four values: MILLISECONDS, SECONDS, MINUTES, and HOURS. (These are NOT case-sensitive)
Make sure the delay type is inside the correct field. Ex: "delayType: SECONDS".
My problem isn't any of these!
Simply post below and I will try to get back to you ASAP.
Or try reading the "/FILES/INFO.txt" file for instructions on how to configure the plug-in properly.
Just to say thank you and make a suggestion. A reload command would be cool and is it possible to make hyperlinks compatible. Some of my links are 5 miles long and when reconfiguring a message I have to restart to see it in chat. Please ignore if these suggestions are already possible or in the works. Thank you again!
Of course I find the perm node page with the reload command on it after this post. :P My bad!
-
View User Profile
-
Send Message
Posted Mar 26, 2014Just to say thank you and make a suggestion. A reload command would be cool and is it possible to make hyperlinks compatible. Some of my links are 5 miles long and when reconfiguring a message I have to restart to see it in chat. Please ignore if these suggestions are already possible or in the works. Thank you again!
Of course I find the perm node page with the reload command on it after this post. :P My bad!