Types

_{d - Delay Available (Go to bottom for more information on delays)}

Logic Gates

OR Gate_d

AND Gate_d

NOR Gate_d

NAND Gate_d

XOR Gate_d

XNOR Gate_d

Utility

Block Breaker

Block Placer

Place Blocks to place in Inputs

Teleporter

To get a Teleporter CPU to work, you must first get a book named "Destination" then write into it with the format [world x y z] on the first page with nothing else. Alternatively you can use "/cpu gettp" or a typifier(while sneaking and clicking on a non-CPU block) to get this Destination book. The Teleporter CPU will find the first* book in its inputs and use the coordinates specified within.

Clock_d

Delay determines pulse length and interval

Pulse Limiter_d

Delay determines the maximum length of signal

Pulse Extender_d

Delay determines the minimum length of signal

Wireless

Use a Nametag with the channel ID then right-click on the middle chest to change the CPUs Wireless ID

ItemSorter

Any items that go into the core using a hopper will be sorted. Put a Book with the Item ID numbers seperated by a comma in each input, any items that have the ID in the book will go to the Inventory of the Input the book is in. If no IDs match and there is a hopper below the core of the CPU then it will go there, you can stack a lot of these to create the ultimate item sorter!

Delays:

Delays are calculated in redstone ticks ( 1 tick is 0.1 seconds or equal to the delay of a repeater at its lowest settings)
Put the following items in INPUT 2 (Right Chest) to determine the length of the delay:

• Gold Ingot = 1 tick (0.1 seconds)
• Iron Ingot = 10 ticks (1 seconds)
• Coal = 100 ticks (10 seconds)
• Gold Block = 9 ticks (0.9 seconds)
• Iron Block = 90 ticks (9 seconds)
• Coal Block = 900 ticks (90 seconds)

Current Max delay is: 1555200 ticks ( 155520 seconds or 43 hours and 12 minutes )
*NOTE: A CPU searches for items from Input 1 to Input 2 prioritizes the first item to appear left to right!


BACK TO PROJECT PAGE